| HP No. 22 + 28 + 57 |
On the label the color chambers are
wrongly marked |
 |
Remove the label
from the top of the printer to expose the filling holes. |
|
|
Tape over the hole
that you are not refilling. |
|
|
Assemble the needle
and syringe and fill with 5cc of the appropriate colour ink. |
|
|
Insert the needle
into the sponge chamber as far as you can then with draw the
needle about 1/6 to 1/8 of an inch. |
|
|
Very slowly inject
the ink into the cartridge sponge (you need to allow the ink
time to saturate the sponge) at the same time withdraw the needle
slightly. |
|
|
When ink start to
form at the vent holes the cartridge is full. |
|
|
Remove the needle
from the cartridge and return any used ink to the bottle. |
|
|
Clean and dry the
needle and syringe with warm water. |
|
|
Repeat the process
until all colour chambers have been refilled, being very careful
to keep the holes for each colour covered. |
|
|
Allow the cartridge
to stand for a few minutes |
|
|
Remove the tape
from the filling holes. |
|
|
Return the cartridge
to the printer and run a cleaning/priming cycle as per your
printer instructions. |
